Protec PROTEK II SF Manual de usuario

Coating Thickness InstrumentsProTek IIS SERIESUser’s GuideProTek II SF _____ProTek II SN _____ProTek II ST _____

104- Press the ON key. The gauge enters to its previous setup without any changes8.0 CHANGING THE BATTERY.When a battery indicator appears on to

21.0 INTRODUCTIONThe ProTek II series Coating Thickness Instrumentsrepresent the latest technology for the non-destructive measurementof surface coat

32.0. EQUIPMENT SUPPLIED2.1 Standard AccessoriesThe ProTek II Series Gauges are supplied with the followingstandard accessories:a. Bare test plate

43.0. KEYPAD FUNCTIONS1. Turns the power onON2. Turns the power off3. Selects displayed value or displayed sub-menu option1. Enters calibration m

54.0 OPERATING PROCEDURE4.1 HANDLE PROBE CAREFULLY4.2 Taking Measurements1. Press the ON key to turn on the power. The LCD will momentarily f

65.0 CALIBRATION5.1 IntroductionThe ProTek II series normally do not require calibrationbefore use. However, whenever the product or part to becheck

7Setting The “ZERO” Point3. After pressing the key, the display will flash “2 PT CAL” followed by “00 PLATE”. An audible “beep” will als

86.0 CHANGING UNITS OF MEASURETo change the units of measure from mils to microns, andvice versa, press the 0N + key.Each time this comb

9After the first measurement is taken, a number will appear on the left side of the display along with the thickness reading on the right. The number